7.3. Rule Reloads¶
Suricata can be told to reloads it’s rules without restarting.
This works by sending Suricata a signal or by using the unix socket. When Suricata is told to reload the rules these are the basic steps it takes:
- Load new config
- Load new rules
- Construct new detection engine
- Swap old and new detection engines
- Make sure all threads are updated
- Free old detection engine
Suricata will continue to process packets normally during this process. Keep in mind though, that the system should have enough memory for both detection engines.
kill -USR2 $(pidof suricata)
Unix socket has two method for rules reload.
suricatasc -c reload-rules
Non blocking reload
suricatasc -c ruleset-reload-nonblocking
It is also possible to get information about the last reload via dedicated commands. See Commands in standard running mode for more information.