5.24. Base64 keywords

Suricata supports decoding base64 encoded data from buffers and matching on the decoded data.

This is achieved by using two keywords, base64_decode and base64_data. Both keywords must be used in order to generate an alert.

5.24.1. base64_decode

Decodes base64_data from a buffer and makes it available for the base64_data function.


base64_decode:bytes <value>, offset <value>, relative;

The bytes option specifies how many bytes Suricata should decode and make available for base64_data. The decoding will stop at the end of the buffer.

The offset option specifies how many bytes Suricata should skip before decoding. Bytes are skipped relative to the start of the payload buffer if the relative is not set.

The relative option makes the decoding start relative to the previous content match. Default behavior is to start at the beginning of the buffer. This option makes offset skip bytes relative to the previous match.


Regarding relative and base64_decode:

The content match that you want to decode relative to must be the first match in the stream.

5.24.2. base64_data

base64_data is a sticky buffer.

Enables content matching on the data previously decoded by base64_decode.

5.24.3. Example

Here is an example of a rule matching on the base64 encoded string “test” that is found inside the http_uri buffer.

It starts decoding relative to the known string “somestring” with the known offset of 1. This must be the first occurrence of “somestring” in the buffer.


Buffer content:
http_uri = "GET /en/somestring&dGVzdAo=&not_base64"

alert http any any -> any any (msg:"Example"; content:"somestring"; base64_decode:bytes 8, offset 1, relative; \
    http_uri; base64_content; content:"test"; sid:10001; rev:1;)